batch lists not saving

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Alex Bowler
Junior Member
Posts: 60
Joined: Mon, Mar 26 2012, 10:40PM
Company Name: cutshop
Country: NEW ZEALAND

batch lists not saving

Post by Alex Bowler »

Hi i just downloaded build 9 and i created a list of panels in the batch (cabinets with only the side remaining, i do this so i can display taping instructions on stickers) i saved it but when i went open it it just sent me back to the main page?
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: batch lists not saving

Post by Scott G Vaal »

Alex Bowler wrote:Hi i just downloaded build 9 and i created a list of panels in the batch (cabinets with only the side remaining, i do this so i can display taping instructions on stickers) i saved it but when i went open it it just sent me back to the main page?
I am not able to reproduce this. Here is what I tried:
1.) I created a cabinet that is only a right end with edge banding
2.) Added 8 different sizes to a batch list
3.) Saved the job
4.) reloaded the job

If you repeat your steps will it happen again? If so, I may need your cabinet and the steps you take.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Post Reply