Odd nesting

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Tim Massa
Senior Member
Posts: 190
Joined: Tue, Sep 19 2006, 7:30PM

Odd nesting

Postby Tim Massa » Wed, Jan 23 2013, 10:30AM

I have a one off cabinet that is nesting single sided material funny. When I nest in e cabs it is doing a flip op on the rafix drill op on the first sheet as other parts are getting system holes, stcc on the "A" face. "A" face is up for the first sheet. Next sheet has only rafix drill ops on two of three parts and the rest is all outline cuts. Since rafix is on the "B" side the rafix are all flips again. Makes sense (though not efficient since all parts could be cut at the same time if the sheet could be flipped).
When I nest the TWD file in the Link I'm getting one of the two flipped parts for rafix drilling, sheet one, as a drill op on the A face. It should be flipped but the link and E-cabs are disagreeing on this. I'm agreeing E-cabs as it is drilling the rafix on the right side. Anyone have this issue between Ecabs nest and Link nests?
Attachments
Nesting between programs issue.jpg

Tim Massa
Senior Member
Posts: 190
Joined: Tue, Sep 19 2006, 7:30PM

Re: Odd nesting

Postby Tim Massa » Wed, Jan 23 2013, 10:33AM

Whoops! Disregard,

TWD file wasn't updated to the changes that were made at the Job level.
Everything good. Premature posting.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 36 guests