MDF Doors not picked up in LDE

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

James Melvin
Junior Member
Posts: 54
Joined: Mon, May 23 2005, 2:03PM
Location: Katonah, NY
Contact:

MDF Doors not picked up in LDE

Postby James Melvin » Tue, Feb 05 2013, 4:42PM

Is it just me or is this another "feature" of the Line Drawing Editor. I have created cabinets with flush MDF doors and drawer fronts. The LDE fails to see any pick-points on the d/d so it is not possible to check their dimensions or distances to/from them and any other pick-point. I have not posted to the forum in some time so excuse me if this is a topic already covered.

Dennis Englert

Re: MDF Doors not picked up in LDE

Postby Dennis Englert » Wed, Feb 06 2013, 2:42PM

No problems with dimensioning a MDF Door. Try changing your selection to wall or room, so that it doesn't try to select the Cabinet or Part.


Dennis

User avatar
Kerry Fullington
Wizard Member
Posts: 4604
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: MDF Doors not picked up in LDE

Postby Kerry Fullington » Thu, Feb 07 2013, 7:27AM

Dennis.

I am holding the "M" Key and as you can see there are no pick nodes on the right corners of the MDF Door.

Clipboard02.jpg
Clipboard02.jpg (7.92 KiB) Viewed 1747 times

Dennis Englert

Re: MDF Doors not picked up in LDE

Postby Dennis Englert » Thu, Feb 07 2013, 7:44AM

I'll report this to programming.

I put together another cabinet that does have "some" nodes on the doors, but none on a mdf drawer front and then there some nodes in space.


Dennis


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 7 guests