MDF Doors not picked up in LDE
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 54
- Joined: Mon, May 23 2005, 2:03PM
- Location: Katonah, NY
- Contact:
MDF Doors not picked up in LDE
Is it just me or is this another "feature" of the Line Drawing Editor. I have created cabinets with flush MDF doors and drawer fronts. The LDE fails to see any pick-points on the d/d so it is not possible to check their dimensions or distances to/from them and any other pick-point. I have not posted to the forum in some time so excuse me if this is a topic already covered.
Re: MDF Doors not picked up in LDE
No problems with dimensioning a MDF Door. Try changing your selection to wall or room, so that it doesn't try to select the Cabinet or Part.
Dennis
Dennis
-
- Wizard Member
- Posts: 4718
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: MDF Doors not picked up in LDE
Dennis.
I am holding the "M" Key and as you can see there are no pick nodes on the right corners of the MDF Door.
I am holding the "M" Key and as you can see there are no pick nodes on the right corners of the MDF Door.
Re: MDF Doors not picked up in LDE
I'll report this to programming.
I put together another cabinet that does have "some" nodes on the doors, but none on a mdf drawer front and then there some nodes in space.
Dennis
I put together another cabinet that does have "some" nodes on the doors, but none on a mdf drawer front and then there some nodes in space.
Dennis