How can I get my initial software program back after losing

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

How can I get my initial software program back after losing

Postby George Davidson » Fri, Oct 04 2013, 12:38PM

I am writing to ask for help in directing me to the correct place that I need to be to help restore my original software. I recently lost everything on my computer to the " Blue Screen of Death", and I am trying to regain access to this program and be able to use it once again. Any help you can give me to this request would be greatly appreciated. :D Thanking you in advance for you kind cooperation in this matter. George Davidson

Daniel Odom
Senior Member
Posts: 204
Joined: Thu, Oct 20 2011, 12:52PM
Company Name: Carlton Kitchen and Bath
Country: UNITED STATES

Re: How can I get my initial software program back after los

Postby Daniel Odom » Mon, Oct 07 2013, 10:24AM

See if you can take your hard disk to someone who specializes in data recovery, most of the data might still be on the disk I would think.

Dennis Englert

Re: How can I get my initial software program back after los

Postby Dennis Englert » Mon, Oct 07 2013, 1:40PM

George,

I've attached a pdf of instructions on downloading eCabinet Systems. After you install it you will need to get a registration code. You can get that online or give me a call.

If your hard drive is readable you should be able to recover your data files or get a service to help recover them. If you did a backup of the eCabinet's files recently, and if that file can be recovered, you should be able to restore it after you install eCabinet Systems.

Good luck,

Dennis
Attachments
Downloading eCabinets.pdf
(586.13 KiB) Downloaded 64 times

User avatar
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

Re: How can I get my initial software program back after los

Postby George Davidson » Tue, Oct 08 2013, 8:56AM

Thank You Dennis


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests