Grain Direction

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Chris B Campbell
Junior Member
Posts: 84
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Grain Direction

Postby Chris B Campbell » Thu, Nov 07 2013, 3:27PM

hey All,

Is it possible to change the grain direction of a face frame made of sheet stock?? I want my rails to have vertical grain.

Thanks,
Chris

Wally Schneeberger
Guru Member
Posts: 473
Joined: Tue, May 17 2005, 1:55PM

Re: Grain Direction

Postby Wally Schneeberger » Fri, Nov 08 2013, 9:53AM

Try switching your height and width measurements.

Forget it it doesn't work !! Maybe add an image with the grain going the other way and create a new sheet stock with that image.
Image

Dennis Englert

Re: Grain Direction

Postby Dennis Englert » Tue, Nov 12 2013, 10:04AM

There isn't a way to toggle the grain direction. Changing your jpg image would not rotate the grain if you are cutting the part only the image.

Dennis


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 6 guests