Shelf Holes in Back

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Stephane Kovari
New Member
Posts: 24
Joined: Fri, Dec 14 2012, 10:08AM
Company Name: Aspec
Country: CANADA
Location: St-Odilon

Shelf Holes in Back

Postby Stephane Kovari » Wed, Feb 26 2014, 10:11AM

I'm looking for a way to put shelf holes into my cabinet's back for when they are wide for extra shelf support.. I'm not sure if this is possible yet..
Also it would be great if the depth of the holes can be set seperately to avoid an extra flip part!

Thanks,
Stéphane

Stephane Kovari
New Member
Posts: 24
Joined: Fri, Dec 14 2012, 10:08AM
Company Name: Aspec
Country: CANADA
Location: St-Odilon

Re: Shelf Holes in Back

Postby Stephane Kovari » Wed, Feb 26 2014, 10:12AM

Didn't realise i already posted this :lol: sorry about that!!!

Mark McCallum
Senior Member
Posts: 231
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Shelf Holes in Back

Postby Mark McCallum » Wed, Feb 26 2014, 4:01PM

Hi Stephane
yes it can be done.
you have to take the parts into the part editor.
you can make up templates in the contour section and save them.
As long as you set up your hole spacings to a standard you can use the same template.
I have attached a corner cupboard where I have put in the extra holes (not tested).
It would be a nice feature to have added to eCabs, a bit similar to the hinge spacing setting.
Attachments
Corner cabinet.jpg
CNR 885x885LHDd.hsf
Corner cab with adj holes in back.
(844.02 KiB) Downloaded 43 times


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 10 guests