Minimums for nesting
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 170
- Joined: Sat, Oct 22 2005, 10:59AM
- Location: Spartanburg, SC
- Contact:
Minimums for nesting
When using a 3/8" cutter, I'm having to program parts 1.5" less than sheet size to get them to nest. It used to be .5" less than sheet size. I think this is a glitch with 13. Anyone else having this problem?
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Minimums for nesting
Ben,
What is your collar set to?
What is your collar set to?
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
-
- Senior Member
- Posts: 170
- Joined: Sat, Oct 22 2005, 10:59AM
- Location: Spartanburg, SC
- Contact:
Re: Minimums for nesting
The problem I'm having is in ecabs. It works fine in CN
-
- Senior Member
- Posts: 209
- Joined: Tue, May 17 2005, 1:05PM
- Company Name: Richmond Cabinet
- Country: UNITED STATES
- Location: Delavan, WI
Re: Minimums for nesting
Check the collar setting in eCabinets > Nest Diagrams.
Dave Egnoski
Richmond Cabinet & Millwork
Richmond Cabinet & Millwork
-
- Senior Member
- Posts: 170
- Joined: Sat, Oct 22 2005, 10:59AM
- Location: Spartanburg, SC
- Contact:
Re: Minimums for nesting
Aha, never seen that before, thanks