Hi,
In part editor, I am able to create a cutout for a circle 5mm to 25mm and so forth but when I try to make a sink cut out it comes up with an error as attached picture will show. I didn’t have this problem before the versions build v6 ver 12 but as soon as I updated to 12 and 13 the ability to do so had gone. I have tried re-doing it I have restarted ecabinets multiple times, restarted computer and also tried on many other materials and everything with this design doesn’t work anymore.
Any help that you guys could give would be much appreciated
thanks
Regards Chris
Detailer at Classic Cabinetry
part editor release 13
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 622
- Joined: Fri, May 20 2005, 6:48PM
- Company Name: Classic Cabinetry
- Location: Albany Western Australia
- Contact:
part editor release 13
Neville Australia
-
- Senior Member
- Posts: 204
- Joined: Thu, Oct 20 2011, 12:52PM
- Company Name: Carlton Kitchen and Bath
- Country: UNITED STATES
Re: part editor release 13
Looks like there is a line connecting the two outline shapes, try deleting it, pocket through the center shape and use profile modeler to create the rebated lip if that's what you're trying to do.
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: part editor release 13
Neville,
I have reproduced the issue here and will get it listed and fixed. As a work around for now, you can widen the gap between the 2 lines so that you have a little over .1" (2.54mm) and it should perform the cut. I used .105" (2.67mm) and it worked for me. Sorry for the inconvenience.
I have reproduced the issue here and will get it listed and fixed. As a work around for now, you can widen the gap between the 2 lines so that you have a little over .1" (2.54mm) and it should perform the cut. I used .105" (2.67mm) and it worked for me. Sorry for the inconvenience.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
-
- Guru Member
- Posts: 622
- Joined: Fri, May 20 2005, 6:48PM
- Company Name: Classic Cabinetry
- Location: Albany Western Australia
- Contact:
Re: part editor release 13
Thanks Scott . The suggestion worked a treat so all smiles here.
Regards
Neville
Regards
Neville
Neville Australia