tool creation problem

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

John Powell
Senior Member
Posts: 114
Joined: Thu, Dec 29 2005, 3:14AM
Location: Perth Western Australia

tool creation problem

Postby John Powell » Sat, May 31 2014, 4:38AM

Hi from OZ.
I have just created a simple 45deg chamfer tool to cut a mitred edge on the end of a panel.
When i select the tool iget a dialog box saying closing tool selection dialog. then it just takes me back
to the previous screen. how do i overcome this problem ?
Thanks in advance John.
Nearly is not enough

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 34 guests