Part Editor_Circle Mode_PROBLEM!

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Vince Lisanti
Senior Member
Posts: 137
Joined: Sat, Jun 11 2005, 7:18AM
Location: Rock Hill, N.Y.
Contact:

Part Editor_Circle Mode_PROBLEM!

Post by Vince Lisanti »

For whatever reason the part editor is not working for me this morning. This is not specific to any one cabinet. Does not work even when using standard cabinets.

I am trying to create a set of holes on the left end of a case. The side that faces out not the interior. I select the part, go into part editor, click back view, click the circle tool, place the hole geometry. When I go to click on the hole geometry so I can use the "Cut/Pocket Using Geometric Shapes" it will not highlight the geometry. Nothing happens.

I am not in closed contour just the main area of the part editor. This is only with the circle tool not the rectangle tool. The rectangle tool works fine.

I really need to get this issue resolved.


Thanks
Dell Precision M4800
Intel(r) core(tm) i7-4800mq cpu @ 2.70ghz
32 GB RAM
NVIDIA Quadro K 2100M
Windows 8.1 Professional 64-bit
Vince Lisanti
Senior Member
Posts: 137
Joined: Sat, Jun 11 2005, 7:18AM
Location: Rock Hill, N.Y.
Contact:

Re: Part Editor_Circle Mode_PROBLEM!

Post by Vince Lisanti »

I figured it out. Somehow the snap setting was set to 0 and that is why I could no select circles
Dell Precision M4800
Intel(r) core(tm) i7-4800mq cpu @ 2.70ghz
32 GB RAM
NVIDIA Quadro K 2100M
Windows 8.1 Professional 64-bit
Post Reply