Control Nesting Off-fall Material

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Stephane Kovari
New Member
Posts: 24
Joined: Fri, Dec 14 2012, 10:08AM
Company Name: Aspec
Country: CANADA
Location: St-Odilon

Control Nesting Off-fall Material

Postby Stephane Kovari » Mon, Jun 16 2014, 7:25AM

Is it possible in the next version of the controll nesting to be able to change the name of Off-fall material to match.
we use the size of the material in the name, therefore a 3/4'' MDF sheet 5x10 off-fall could be used in a job using only 3/4'' MDF 4x8 sheets
This would save a couple minutes each time creating a new custom sheet to match the existing off-fall!!!!


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 18 guests