3 posts • Page 1 of 1
- Junior Member
- Posts: 77
- Joined: Thu, Aug 16 2007, 4:20AM
- Location: County Durham, United Kingdom
Hi, is it possible to have E/Cabs place a hole in the backs automatically when adding an adjustable shelf such as a situation where the shelf is 1000mm long.
- Senior Member
- Posts: 204
- Joined: Thu, Oct 20 2011, 12:52PM
- Company Name: Carlton Kitchen and Bath
- Country: UNITED STATES
Never though about doing it this way but one way that might work would be to add the adjustable shelf as a "fixed" shelf and use rta hole pattern on all 3 sides. You'll have to set up a hole pattern that is one hole center and however many above and below it but I think that should work? I don't know I'll try it later on and see.
Who is online
Users browsing this forum: No registered users and 14 guests