Shelf holes in cabinet backs

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Stephen Tinkler
Junior Member
Posts: 77
Joined: Thu, Aug 16 2007, 4:20AM
Location: County Durham, United Kingdom

Shelf holes in cabinet backs

Postby Stephen Tinkler » Thu, Jun 26 2014, 3:35AM

Hi, is it possible to have E/Cabs place a hole in the backs automatically when adding an adjustable shelf such as a situation where the shelf is 1000mm long. :?
Cheers Stephen

Daniel Odom
Senior Member
Posts: 204
Joined: Thu, Oct 20 2011, 12:52PM
Company Name: Carlton Kitchen and Bath
Country: UNITED STATES

Re: Shelf holes in cabinet backs

Postby Daniel Odom » Thu, Jun 26 2014, 11:54AM

Never though about doing it this way but one way that might work would be to add the adjustable shelf as a "fixed" shelf and use rta hole pattern on all 3 sides. You'll have to set up a hole pattern that is one hole center and however many above and below it but I think that should work? I don't know I'll try it later on and see.

Dennis Englert

Re: Shelf holes in cabinet backs

Postby Dennis Englert » Fri, Jun 27 2014, 6:54AM

That sounds perfectly feasible to me. Nice solution.

Dennis


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 6 guests