Door Hardware hole Pattern

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Ted Illi
New Member
Posts: 13
Joined: Tue, May 12 2009, 9:45AM
Company Name: Vanity Fair Custom Cabinetry

Door Hardware hole Pattern

Postby Ted Illi » Wed, Sep 03 2014, 8:51AM

I've done everything the same per the training instructions etc and get the hole patterns the way I want them for everything. The drawer slides and door hinge mount show up perfectly but the door hinge hole (35mm hole) pattern does not show up? The slides, hinges, and mounts all show with the correct number up in the buy list. Whats going on? Any help appreciated..... very frustrated to say the least! :(

Thanks
Ted

Dennis Englert

Re: Door Hardware hole Pattern

Postby Dennis Englert » Wed, Sep 03 2014, 1:50PM

Ted,
Send your cabinet to cabinets@thermwood.com


Dennis

Ted Illi
New Member
Posts: 13
Joined: Tue, May 12 2009, 9:45AM
Company Name: Vanity Fair Custom Cabinetry

Re: Door Hardware hole Pattern

Postby Ted Illi » Thu, Sep 04 2014, 7:59AM

Dennis Englert wrote:Ted,
Send your cabinet to cabinets@thermwood.com


Dennis


Please find attached the cabinet in question. Hope this is the correct file? This same problem is happening to all cabinets. Hope you can lend some assistance. Thanking you in advance
Ted Illi
Attachments
60 Vanity Ft.hsf
(2.04 MiB) Downloaded 61 times

User avatar
Brad McIntosh
Guru Member
Posts: 480
Joined: Wed, May 18 2005, 6:59PM
Company Name: CNC Automation
Location: St. Zotique, Québec, Canada
Contact:

Re: Door Hardware hole Pattern

Postby Brad McIntosh » Thu, Sep 04 2014, 8:20AM

Ted,

I believe Dennis had wanted you to email the cabinet to the support group. Hopefully someone there will review this thread and see your attachment.

Dennis Englert

Re: Door Hardware hole Pattern

Postby Dennis Englert » Thu, Sep 04 2014, 8:30AM

Saw the post this morning.

While the doors are designated as Build in House, these are 5 piece doors will not show the hole pattern. It does not cut these doors on the machine. If you replace the doors with a slab door, you will see a pattern.

Dennis

Ted Illi
New Member
Posts: 13
Joined: Tue, May 12 2009, 9:45AM
Company Name: Vanity Fair Custom Cabinetry

Re: Door Hardware hole Pattern

Postby Ted Illi » Wed, Sep 10 2014, 9:21AM

Thanks much to all. I now understand why the holes don't show up or get drilled. However the holes still need to be drilled? Also now know why in house 5 piece flat panel doors made with sheet stock don't get nested or cut either. Is a separate door program for building in house doors required? Wondering what others do to run in house doors components?
Ted


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 6 guests