Width of angled back on corner cab

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Tim Massa
Senior Member
Posts: 190
Joined: Tue, Sep 19 2006, 7:30PM

Width of angled back on corner cab

Postby Tim Massa » Wed, Nov 05 2014, 9:57AM

Would anyone be able to remind me if there is a way to change the width of the angled (center) back of the 90 degree corner cab? If it can be eliminated at all?

Thanks,
Tim

User avatar
Scott G Vaal
Thermwood Team
Posts: 1741
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Width of angled back on corner cab

Postby Scott G Vaal » Wed, Nov 05 2014, 10:03AM

Tim,

This is controlled by the Corner Gap setting on the Corner Settings tab of construction settings. If you make it a larger value, the center back will get wider. If you set this to zero (0), it will remove it all together. Hope this helps.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000

Tim Massa
Senior Member
Posts: 190
Joined: Tue, Sep 19 2006, 7:30PM

Re: Width of angled back on corner cab

Postby Tim Massa » Thu, Nov 06 2014, 4:19PM

Thanks Scott!

Dennis Englert

Re: Width of angled back on corner cab

Postby Dennis Englert » Fri, Nov 07 2014, 7:22AM

Also, the width of the center back is double the corner gap.

Dennis


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Yahoo [Bot] and 10 guests