Nesting trouble in Link

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Tim Massa
Senior Member
Posts: 190
Joined: Tue, Sep 19 2006, 7:30PM

Nesting trouble in Link

Postby Tim Massa » Tue, Nov 18 2014, 7:27PM

Hi All,

STILL having trouble with the back of the larger cabinet from this assembly nesting in Ecab Link. It will now nest in Ecabs but gets spit out in the link nest. Would anyone be able to take a look at what may be causing this issue? I'm using a .25" collar and cutting with .25" M.C. bits. Material is speced at 47"x97".
I can run the rest of the job and turn off this part. I'll wind up cutting it in another program to get it done but It's getting to me not knowing why this gets spit back out of the nest.

Any help would be appreciated.

Regards,
Tim
Attachments
Dunn Nook hall storage.esj
(1.84 MiB) Downloaded 45 times

tim lucas
Guru Member
Posts: 252
Joined: Thu, Nov 29 2007, 5:18PM
Company Name: Tim Lucas Custom Woodworks LLC
Country: UNITED STATES
Location: bell, florida
Contact:

Re: Nesting trouble in Link

Postby tim lucas » Wed, Nov 19 2014, 7:01AM

Good morning Tim,

When I loaded the cabinet your material had to load and the .77MDF loaded with a width of 1/2" so the right side would not nest in ecabs, I changed the material to my MDF material and it nested fine. The base unit back would not net either with my 1/2" collar in ecabs but when I changed it to 1/4" it nested fine.

Now in SBlink I can not see your setup but it nested fine with "Nest to edge of sheet" checked and the side material changed.

Hope this helps
Tim
HP Desktop
i5 2400 @ 3.10 GHz
8.0 G Ram
Win 7 Pro
Nvidia Quadro NVS 290

Blessed is the man who finds wisdom,
the man who gains understanding.

Tim Massa
Senior Member
Posts: 190
Joined: Tue, Sep 19 2006, 7:30PM

Re: Nesting trouble in Link

Postby Tim Massa » Wed, Nov 19 2014, 9:54AM

Thanks Tim,

I'll try fiddling with the Link settings some more to see if I can get it to nest. Much appreciated.

Tim


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 10 guests