I am just changing from Hettich drawers to Blum and was wondering if someone is willing to send there drilling patterns for Blum TandemBox slide including the 10mm front fixing holes.
It would be good to have a system that has been fine tuned on actual cabinets. We do the euro / frameless cabinets but I am not sure that matters compared to framed?
If you could email them to neville at classiccabinetry dot biz or post them here as a reply for future users searches that would be greatly apprecated.
1 post • Page 1 of 1
- Neville Bastian
- Guru Member
- Posts: 598
- Joined: Fri, May 20 2005, 6:48PM
- Company Name: Classic Cabinetry
- Location: Albany Western Australia
Who is online
Users browsing this forum: No registered users and 18 guests