Build 16 Appliances

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Wally Schneeberger
Guru Member
Posts: 475
Joined: Tue, May 17 2005, 1:55PM

Build 16 Appliances

Postby Wally Schneeberger » Fri, Apr 10 2015, 9:23AM

Can anyone tell me if there is a problem setting appliances in a room?? I can pick and move them but I can't place them.
s.esj
(866.02 KiB) Downloaded 210 times


EC.jpg
Image

User avatar
Kerry Fullington
Wizard Member
Posts: 4604
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: Build 16 Appliances

Postby Kerry Fullington » Fri, Apr 10 2015, 11:11AM

Wally,
I didn't have any problem placing a range in your room. Make sure you have Align to Back selected so that the appliance will snap to the wall.

The only thing I see that might be a problem is that you have a bunch of walls that are not actually connected. This might cause a problem if the software can't decide which wall it is looking at. Just a guess.

Wally Schneeberger
Guru Member
Posts: 475
Joined: Tue, May 17 2005, 1:55PM

Re: Build 16 Appliances

Postby Wally Schneeberger » Fri, Apr 10 2015, 11:27AM

That worked for a bit and then when I set the fridge the stove disappeared. I had to do it again. I always set Free Style and have never had any problems until now. Oh well -- we'll try and get through it. Thanks Kerry.
Image

Wally Schneeberger
Guru Member
Posts: 475
Joined: Tue, May 17 2005, 1:55PM

Re: Build 16 Appliances

Postby Wally Schneeberger » Fri, Apr 10 2015, 11:57AM

Kerry -- Since you already downloaded the layout can you tell me why my arch above the door in wall #3 doesn't show up?? TIA.
Image

Al dedenus
Guru Member
Posts: 269
Joined: Sun, Apr 29 2007, 8:53PM
Company Name: Creative Kitchens and Interior
Country: NEW ZEALAND
Location: Tauranga New Zealand

Re: Build 16 Appliances

Postby Al dedenus » Sat, Apr 11 2015, 3:34PM

Wally
I couldn't get the arch to show either but deleted wall3 and after recreating it had no problems cutting the geometry
Appliances loaded fine for me

Wally Schneeberger
Guru Member
Posts: 475
Joined: Tue, May 17 2005, 1:55PM

Re: Build 16 Appliances

Postby Wally Schneeberger » Sun, Apr 12 2015, 10:40AM

Thanks Al!!
Image


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 13 guests