Build 16 Appliances

Wally Schneeberger · Post by **Wally Schneeberger** » Fri, Apr 10 2015, 9:23AM

Can anyone tell me if there is a problem setting appliances in a room?? I can pick and move them but I can't place them.

s.esj: (866.02 KiB) Downloaded 614 times

Kerry Fullington · Post by **Kerry Fullington** » Fri, Apr 10 2015, 11:11AM

Wally,
I didn't have any problem placing a range in your room. Make sure you have Align to Back selected so that the appliance will snap to the wall.

The only thing I see that might be a problem is that you have a bunch of walls that are not actually connected. This might cause a problem if the software can't decide which wall it is looking at. Just a guess.

Wally Schneeberger · Post by **Wally Schneeberger** » Fri, Apr 10 2015, 11:27AM

That worked for a bit and then when I set the fridge the stove disappeared. I had to do it again. I always set Free Style and have never had any problems until now. Oh well -- we'll try and get through it. Thanks Kerry.

Wally Schneeberger · Post by **Wally Schneeberger** » Fri, Apr 10 2015, 11:57AM

Kerry -- Since you already downloaded the layout can you tell me why my arch above the door in wall #3 doesn't show up?? TIA.

Al dedenus · Post by **Al dedenus** » Sat, Apr 11 2015, 3:34PM

Wally
I couldn't get the arch to show either but deleted wall3 and after recreating it had no problems cutting the geometry
Appliances loaded fine for me

Wally Schneeberger · Post by **Wally Schneeberger** » Sun, Apr 12 2015, 10:40AM

Thanks Al!!

Thermwood / eCabinet Systems

Build 16 Appliances

Build 16 Appliances

Re: Build 16 Appliances

Re: Build 16 Appliances

Re: Build 16 Appliances

Re: Build 16 Appliances

Re: Build 16 Appliances