Problem grouping drawer fronts

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Jason Gooch
Guru Member
Posts: 532
Joined: Thu, Jun 23 2005, 12:26AM
Location: San Francisco

Problem grouping drawer fronts

Postby Jason Gooch » Wed, Apr 22 2015, 7:22PM

Hi folks - trying to group the drawer fronts of this cabinet so they come from the same sheet of material. The drawers are not adjacent to each other, which seems to be throwing off the software - when I try to nest, it tells me it's unable to nest those drawer fronts. When I group them separately (ie: each bank of drawers has it's own group) they nest fine, however they end up on different sheets.

This is also happening when grouping non-adjacent fronts in an assembly. The bench cabinet has 3 stacks of drawers, I want to match the two outside stacks but the software flips out and says it can't nest. Are these glitches, or just not possible?

I'll attach the cabinets - thanks - Jason
Attachments
benchFIN.jpg
benchFIN.jpg (8.25 KiB) Viewed 1002 times
benchFIN.esa
(1.4 MiB) Downloaded 92 times
ninaFIN.jpg
ninaFIN.jpg (13.7 KiB) Viewed 1002 times
ninaFIN.hsf
(1.18 MiB) Downloaded 93 times
Applebox Cabinetry and Furniture
www.appleboxwood.com

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 5 guests