Error in contour editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- eCabinets Beta Tester
- Posts: 1119
- Joined: Tue, May 10 2005, 9:36PM
- Company Name: Corlane Custom Cabinetry LLC
- Country: UNITED STATES
- Location: Carnesville, GA
- Contact:
Error in contour editor
Hola, go to cabinet editor (don't load a cabinet) and load a 12" x 12" 3/4" Generic display panel. Take it to the part editor, then contour editor. Draw a straight horizontal line near the top, ~10" long (not critical). Click Offset, and create a duplicate ~8" below. Now (making sure object snap is on) connect the two lines to form a rectangle. Click Radius, set to 1", then attempt to radius the four corners. On both of our design computers, we get the attached message. ("cannot fillet the bodies, because they do not intersect")
http://www.corlanecabinetry.com
Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit
CS-41 4x8
CS-45 5x12
Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit
CS-41 4x8
CS-45 5x12
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Error in contour editor
It seems to be only the bottom right corner, but if you connect through the lines all is well.
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Error in contour editor
Jeremy,
Thanks for reporting this. It will be resolved in the next version.
Thanks for reporting this. It will be resolved in the next version.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000