Aventos - style doors

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Aventos - style doors

Post by Mark Hesketh »

IS there a way to have a door automatically add the proper hardware holes for an Aventos-style swing-up door? It would have to be related to the top of the door only... We add these to a lot of different cabinets and it would be much easier if we could just select a different hardware pattern when adding the door.

I'm thinking for the lift mechanisms that mount to the gables as well as the hinges that may/may not be needed across the top of the cabinet.
ACE Mirabel Mike
New Member
Posts: 1
Joined: Fri, Aug 31 2018, 2:50PM
Company Name: ACE Concept inc
Country: CANADA

Re: Aventos - style doors

Post by ACE Mirabel Mike »

Hi Mark,

I'm installing Aventos as well.

Did you received any answer so far on this topic ?
Did you find a way to work this out ?

Thank you
Michel Pilon
ACE Concept inc.
Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Re: Aventos - style doors

Post by Mark Hesketh »

No, I haven't figured out a way to do it through applied hardware settings or anything.
I ended up making a couple of Part Editor "blocks" that I can bring in and then use Constraint Manager to move them into the correct spot. It's a couple of extra steps, but it works
Post Reply