Countertop fillet

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
tim lucas
Guru Member
Posts: 322
Joined: Thu, Nov 29 2007, 5:18PM
Company Name: Tim Lucas Custom Woodworks LLC
Country: UNITED STATES
Location: bell, florida
Contact:

Countertop fillet

Post by tim lucas »

Trying to fillet a corner this morning and it wont select the long front edge, it will select the short edge in front of the angle base. Want to fillet the left front corner. I did double check the edge to make sure it is a front edge, selects left edge ok.
Tim
Capture.PNG
Capture.PNG (3.64 KiB) Viewed 3545 times
Tim Lucas Custom Woodworks LLC
www.TLCW.us
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Countertop fillet

Post by Scott G Vaal »

Tim,

I am unable to reproduce it here. Can you attach the job that this c-top is in and I will see it the same issue happens for me. If you would rather email it, send it to cabinets@thermwood.com ( please put attn: Scott in the subject line). Also, please let me know here on the forum if you choose to emailed it (sometimes it can get caught by the spam filter and I may not see it right away). Thanks.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
tim lucas
Guru Member
Posts: 322
Joined: Thu, Nov 29 2007, 5:18PM
Company Name: Tim Lucas Custom Woodworks LLC
Country: UNITED STATES
Location: bell, florida
Contact:

Re: Countertop fillet

Post by tim lucas »

Hi Scott,

Emailed the job to you this morning

Thanks
Tim
Tim Lucas Custom Woodworks LLC
www.TLCW.us
Post Reply