Would it be possible too

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Scott Marshburn
Guru Member
Posts: 744
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Would it be possible too

Postby Scott Marshburn » Sun, Jun 28 2015, 2:02PM

Allow to use the pocket hole feature with blind and full dadoes. We dado our face frames into our ends. If I use the lock dado w/Pocket Screw I cannot set the top and bottom insets to 0 and offset the pocket screw also. If I set the top and bottom inset to say 3 inches then the ends will be notched out by this amount, leaving a void. I know that this would be no problem for the base cabinets or the tops of the uppers but the bottoms would not go over well. In the mage below I have the top and bottom inset set to 0 inches.
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips

Scott Marshburn
Guru Member
Posts: 744
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: Would it be possible too

Postby Scott Marshburn » Sun, Jun 28 2015, 3:57PM

Ok so I did not upload the image. Here it is
Attachments
Pocket Screw.jpg
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 4 guests