Paneling With a V Groove

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Troy Hollinshead
New Member
Posts: 14
Joined: Wed, Apr 30 2014, 4:13PM
Company Name: Leidys Custom Woodworking
Country: UNITED STATES
Location: Mercersburg, Pennsylvania
Contact:

Paneling With a V Groove

Postby Troy Hollinshead » Wed, Aug 19 2015, 10:49AM

48 X 96 Paneling V Groove.JPG
48 X 96 Paneling V Groove.JPG (9.97 KiB) Viewed 1046 times
I have to make a few pieces of paneling with a V Groove.
I have Drawn the 90° Bit and created the .tol file
when i nest in ecabs I cannot see any of the tool paths for the V bit.
I output to the machine then open in profile modeler.
I can see all the tool paths but get "Region" errors.

I have used the profile modeler to do miters on cabinet sides using a 1/2 in strait bit.
I have taken out my 1/2 strait bit and replaced it with a V bit and cannot get a simple
center line cut .037 deep.


Driving me nuts!!!
Attachments
90 Degree V Bit.tol
(2.99 KiB) Downloaded 72 times
48 X 96 Paneling V Groove.esa
(444.02 KiB) Downloaded 83 times

User avatar
Troy Hollinshead
New Member
Posts: 14
Joined: Wed, Apr 30 2014, 4:13PM
Company Name: Leidys Custom Woodworking
Country: UNITED STATES
Location: Mercersburg, Pennsylvania
Contact:

Re: Paneling With a V Groove

Postby Troy Hollinshead » Wed, Aug 19 2015, 2:10PM

Got it!

Had to Choose Custom Tool in profile modeler for each region.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests