Paneling With a V Groove
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 58
- Joined: Wed, Apr 30 2014, 4:13PM
- Company Name: Leidys Custom Woodworking
- Country: UNITED STATES
- Location: Mercersburg, Pennsylvania
- Contact:
Paneling With a V Groove
I have Drawn the 90° Bit and created the .tol file
when i nest in ecabs I cannot see any of the tool paths for the V bit.
I output to the machine then open in profile modeler.
I can see all the tool paths but get "Region" errors.
I have used the profile modeler to do miters on cabinet sides using a 1/2 in strait bit.
I have taken out my 1/2 strait bit and replaced it with a V bit and cannot get a simple
center line cut .037 deep.
Driving me nuts!!!
- Attachments
-
- 90 Degree V Bit.tol
- (2.99 KiB) Downloaded 318 times
-
- 48 X 96 Paneling V Groove.esa
- (444.02 KiB) Downloaded 353 times
-
- Junior Member
- Posts: 58
- Joined: Wed, Apr 30 2014, 4:13PM
- Company Name: Leidys Custom Woodworking
- Country: UNITED STATES
- Location: Mercersburg, Pennsylvania
- Contact:
Re: Paneling With a V Groove
Got it!
Had to Choose Custom Tool in profile modeler for each region.
Had to Choose Custom Tool in profile modeler for each region.