Here is a quick video on how I drew a cutter in shape manager to make a half round beaded column. This particular column is not intended to be machined on the router. Although I have actually cut one that I tweaked. It was ¾ thick x 2” and it turned out quite well.
Here is the link if you want to check it out.
1 post • Page 1 of 1
- Guru Member
- Posts: 746
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
Who is online
Users browsing this forum: No registered users and 16 guests