Formula in hole settings

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Shaun Just
New Member
Posts: 15
Joined: Mon, Dec 08 2014, 11:13PM
Company Name: Not Just Kitchens LTD
Country: NEW ZEALAND

Formula in hole settings

Post by Shaun Just »

Hi,

Just came across that the formula settings when in shelf hole settings is giving incorrect values.

Ie: Cabinet width of 700mm, I go to apply holes on the back of a cabinet on the left inset with the formula: CabinetWidth/3 which should be 233.33mm but it says 5926.68mm?? Same happens on the right inset.

I am wanting to have 2 holes on the cabinet back divided evenly. Am I going about this wrong?

Thanks
Post Reply