Hello E-cab experts...been a long time since I've been on here.
My question is....can I create a sloped ceiling with trays, coffures and beams in Ecabs and what tools in the software used to create the ceiling coffures. Thanks for any help with this.
Ted
sloped ceiling with coffures and soffits
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 2
- Joined: Sun, Nov 08 2015, 7:13PM
- Company Name: Allen Construction
- Country: UNITED STATES
-
- Wizard Member
- Posts: 4722
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: sloped ceiling with coffures and soffits
This coffered ceiling is just a single cabinet made from a material 4" Beams. You can put a back in if you want a wood look above the beams but it makes lighting the room harder.
This is an old design of mine using this technique.
This is an old design of mine using this technique.
-
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: sloped ceiling with coffures and soffits
HI Kerry very "NICE"
The good old DAYS I started out with a 1966 supper van was 10 years old I wanted to get all the bugs out of it.
Here is what my sons have today!!!!
The good old DAYS I started out with a 1966 supper van was 10 years old I wanted to get all the bugs out of it.
Here is what my sons have today!!!!
-
- New Member
- Posts: 2
- Joined: Sun, Nov 08 2015, 7:13PM
- Company Name: Allen Construction
- Country: UNITED STATES
Re: sloped ceiling with coffures and soffits
Hi Kerry, thanks for the reply...This ceiling is in a church...48x88 with the slopes on the long side. there is a section on both sides of the peak about 20ft by 48 with some recessed trays up in the ceiling. It is all drywall and the walls of these trays are vertical or plumb. Can I build an assembly this large in the software?