Hey All,
We have been doing a few beaded face frames using the Kreg jig. Actually works pretty good. What I would like to do is give the cut out/build sheets to the shop with dimensioned F/F centers, in other words I would like to give the shop the center of two mid rails so there's no mistake in were to cut out the 3/8" deep X 2" notches on the stiles. No math for the shop... Make sense??
Tried going from board stock to sheet stock still will only give me the corners to select for dimensions.
Thanks,
Chris
Beaded face Frames
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 113
- Joined: Fri, Jul 29 2005, 4:00PM
- Location: Helendale, CA.