Corner Cabinet

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Audrey Racine
eCabinets Beta Tester
Posts: 141
Joined: Tue, May 17 2005, 6:31AM
Location: Canada, Quebec city

Corner Cabinet

Postby Audrey Racine » Tue, Jun 07 2016, 2:51PM

Hi,

Here I have a problem with upper and lower corner cabinet.

I do set my deck with the lock dado construction. If you look at the left back width you will it is set as 24.25'' and the right dept at 23.5''. When I do this, there is a problem with the left deck edge construction. If I put the left width at 24.5'' everything is ok.

For upper cabinet it is the same thing but with regular dado construction.

Thank you!
Attachments
Corner 2.jpg
Corner 1.jpg

Ralph Balanik
Senior Member
Posts: 121
Joined: Fri, Jul 30 2010, 5:33PM
Company Name: Ralph Balanik
Country: CANADA

Re: Corner Cabinet

Postby Ralph Balanik » Mon, Jun 13 2016, 9:06AM

Good morning,
It would seem that either the software has a glich or by design it will not make a proper lock dado joint on a blind corner cabinet with the blind end being flush with the door, at least it will not fit the Dado or the KD fitting properly. It would seem that this is some thing that has been going unnoticed for some time. I have reproduced this in the beta, and the 6.1.1 release and maybe before that. Let's hope someone in the programming department might take a look at this and respond.

Clint Buechlein
Thermwood Team
Posts: 170
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Corner Cabinet

Postby Clint Buechlein » Fri, Jun 17 2016, 10:50AM

Audrey,

Can you send the cabinet you are working with to cabinets@thermwood.com so I can take a look at it? If it were me making a blind corner back, I probably would just use a lower cabinet and add parts as needed rather than use a corner cabinet. I haven't designed any myself with it, so there may be something I'm missing.

-Clint-

Rick Deskins
Thermwood Team
Posts: 828
Joined: Tue, May 17 2005, 12:47PM
Company Name: Thermwood
Country: UNITED STATES
Location: Thermwood

Re: Corner Cabinet

Postby Rick Deskins » Wed, Jun 22 2016, 6:57AM

I have reproduced this will get it listed and fixed. Thanks.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Forrest Chapman, Google [Bot] and 4 guests