Stretcher editor inconsistencies

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Stretcher editor inconsistencies

Post by Donald Thomson »

I've noticed when I go to stretcher editor and select a stretcher to work on it, it never gets deselected. I found when I go back to Main, the stretcher is still selected. I've figured this out when I go to do some edgebanding and only the selected part (stretcher) is offered up for edgebanding. Maybe this could be addresses in the next release?

Thank you.
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Post Reply