Part editor on multiple sides of a cube?

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Carmen Addamo
Senior Member
Posts: 118
Joined: Sun, Oct 19 2014, 8:33PM
Company Name: Frank Raffaele and Sons Custom
Country: UNITED STATES

Part editor on multiple sides of a cube?

Post by Carmen Addamo »

In it's simplest form I have a display cube. I want to apply part editor cuts to the face and also to the top. Is there any way to do so.

The project is a vanity with two towers. Between the towers sits an arched bridge (soffit). The bottom of the soffit will have a frame and panel effect. To create the f & p in the software I took a display cube created a 3/4" thick arched panel. No problem. Now I want to cut squares out of the center leaving only 4" rails and stiles. Part editor only allows me to access front/back view. I can't apply cuts to the top/bottom unless you guys know something I don't (hopefully).

It seems that I will be forced to create all individual arched rails and stiles and then create an assembly. Much more time consuming.
Post Reply