Double door reveals

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Double door reveals

Post by Chris B Campbell »

Is there a way to get a different reveal on one side of a double door. For instance I have a double door cabinet I need 0 reveal on the left and .1875 on the right. Dialog box only gives and hinge side reveal and open side reveal, in this instance both sides are hinged. I tried deleting shelves, install a partition and made the adjustments in the dialog, this worked until I deleted the partition then the doors disappeared.
This is a Euro-style cab.
Any help?

Thanks,
Chris
Forrest Chapman
eCabinets Beta Tester
Posts: 1230
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Re: Double door reveals

Post by Forrest Chapman »

Chris, after you add the doors click on (highlight) the one you want to change. Go into construction settings and make your change for the hinge side. Understand that if you ever delete the doors and add them back it will use this new setting for both sides.

Forrest
Carmen Addamo
Senior Member
Posts: 118
Joined: Sun, Oct 19 2014, 8:33PM
Company Name: Frank Raffaele and Sons Custom
Country: UNITED STATES

Re: Double door reveals

Post by Carmen Addamo »

Forrest has a good solution. When I have the situation you describe I always just make the reveal settings so the reveal total is first calculated and then divide equally (divide by 3 in your double door case). This is so both doors are the same width and only their location on the cabinet is slightly shifted. Less confusion IMO whether you build in house or outsource. Also even though no one would notice it does not seem correct from a design standpoint to have one door 18" and the other 18 1/8" on the same cab.
Forrest Chapman
eCabinets Beta Tester
Posts: 1230
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Re: Double door reveals

Post by Forrest Chapman »

Carmen, Thanks for catching that. It used to not function that way so I didn't even look at it this time. I'll ask the programmers about it.

Forrest
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: Double door reveals

Post by Kerry Fullington »

Chris,

Select your opening in the Door Editor
Click on the Add Double door Button
The Add double door Dialogue box will appear and here you can enter a left Reveal and a right reveal
Forrest Chapman
eCabinets Beta Tester
Posts: 1230
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Re: Double door reveals

Post by Forrest Chapman »

YES! I knew there was a way I used to do it. Thanks Kerry.

Forrest
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: Double door reveals

Post by Chris B Campbell »

Thank You... Double click, who wood'a guessed. :roll:

Thanks Again ,
Chris
Post Reply