Stretcher position issue

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Donald Thomson
Guru Member
Posts: 689
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA

Stretcher position issue

Postby Donald Thomson » Mon, Nov 14 2016, 1:23PM

Not sure what is happening here. I've set INSET 1 for both the center left-right stretchers in the attached cabinet (jpg also attached) at 13.25". However, when you view it, they are not at the same position. Take cabinet into faceframe editor and you can see the difference their position.

This is happening in two different cabinets.

Is this a display issue or a positioning issue? Yes, video drivers are up to date with manufacturers (not Windows) drivers.

Thank you.
Guest vanity.hsf
(3.1 MiB) Downloaded 28 times
ERROR - Stretcher spacing issue.jpg

Don Thomson
Diamond Lake Custom Woodworks, LLC
Newport, WA

Clint Buechlein
Thermwood Team
Posts: 229
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp

Re: Stretcher position issue

Postby Clint Buechlein » Mon, Nov 14 2016, 2:45PM


In your attached picture, on the left stretcher, Inset 1 is referencing the top of the partition. The right stretcher Inset 1 is referencing the top of the end panel. The partition is under the top where as the end is above it. You'll need a numerical difference in them to achieve the same dimensions. If you don't feel like doing the math and want to make it like the other, you can delete the stretcher and add back in choosing the side first, then the partition. Or you can use the installed stretcher, go to the advanced tab, and set Inset 1 to reference the top of the right end.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 6 guests