Uh Oh on 6.1.3 update

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Uh Oh on 6.1.3 update

Post by Donald Thomson »

Not sure whats going on with this cabinet but I can't make any changes to it since I upgraded to 6.1.3. I could make all the changes I wanted in 6.1.2.

Went in to delete a shelf and a partition. Clicked on Main and started getting errors.

Please help!! :wall:
Attachments
Untitled2.jpg
Untitled.png
Untitled.png (3.72 KiB) Viewed 5317 times
Oven cabinet.hsf
(1.61 MiB) Downloaded 338 times
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Rick Deskins
Thermwood Team
Posts: 857
Joined: Tue, May 17 2005, 12:47PM
Company Name: Thermwood
Country: UNITED STATES
Location: Thermwood

Re: Uh Oh on 6.1.3 update

Post by Rick Deskins »

Were you working in the batch or room and sending cabinets to the cabinet editor in 6.1.2? There was a bug in 6.1.2 where if you took a cabinet from the batch/room to cabinet editor then return to batch/room and selected no to save changes, it would lose pe cuts for that cabinet If you did this, you would need to recreate your batch/room in 6.1.3 from your seed cabinets.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Uh Oh on 6.1.3 update

Post by Donald Thomson »

Holy crap! That's a lot of work to recreate everything and have to do all the PE editing again.
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Rick Deskins
Thermwood Team
Posts: 857
Joined: Tue, May 17 2005, 12:47PM
Company Name: Thermwood
Country: UNITED STATES
Location: Thermwood

Re: Uh Oh on 6.1.3 update

Post by Rick Deskins »

Donald Thomson wrote:Holy crap! That's a lot of work to recreate everything and have to do all the PE editing again.
If you have the orginial cabinet, you can just delete out the bad cabinet, and add it back. Then, go delete your shelf and partition.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
Post Reply