Not sure whats going on with this cabinet but I can't make any changes to it since I upgraded to 6.1.3. I could make all the changes I wanted in 6.1.2.
Went in to delete a shelf and a partition. Clicked on Main and started getting errors.
Please help!!
Uh Oh on 6.1.3 update
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 833
- Joined: Thu, May 14 2009, 11:41PM
- Company Name: Diamond Lake Custom Woodworks
- Location: Newport, WA
- Contact:
Uh Oh on 6.1.3 update
- Attachments
-
- Untitled.png (3.72 KiB) Viewed 5325 times
-
- Oven cabinet.hsf
- (1.61 MiB) Downloaded 340 times
Sincerely,
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
-
- Thermwood Team
- Posts: 857
- Joined: Tue, May 17 2005, 12:47PM
- Company Name: Thermwood
- Country: UNITED STATES
- Location: Thermwood
Re: Uh Oh on 6.1.3 update
Were you working in the batch or room and sending cabinets to the cabinet editor in 6.1.2? There was a bug in 6.1.2 where if you took a cabinet from the batch/room to cabinet editor then return to batch/room and selected no to save changes, it would lose pe cuts for that cabinet If you did this, you would need to recreate your batch/room in 6.1.3 from your seed cabinets.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
-
- Guru Member
- Posts: 833
- Joined: Thu, May 14 2009, 11:41PM
- Company Name: Diamond Lake Custom Woodworks
- Location: Newport, WA
- Contact:
Re: Uh Oh on 6.1.3 update
Holy crap! That's a lot of work to recreate everything and have to do all the PE editing again.
Sincerely,
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
-
- Thermwood Team
- Posts: 857
- Joined: Tue, May 17 2005, 12:47PM
- Company Name: Thermwood
- Country: UNITED STATES
- Location: Thermwood
Re: Uh Oh on 6.1.3 update
If you have the orginial cabinet, you can just delete out the bad cabinet, and add it back. Then, go delete your shelf and partition.Donald Thomson wrote:Holy crap! That's a lot of work to recreate everything and have to do all the PE editing again.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900