Nesting orientation issue?

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Donald Thomson
Guru Member
Posts: 720
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA

Nesting orientation issue?

Postby Donald Thomson » Sun, Dec 11 2016, 12:00PM

I have a drawer box that I made. In the settings I've specified that I want the grain orientation of the front and back to be up and down (rotate 90 degrees in settings). It is displayed properly in the dbx editor.

However, when I go to nest the cabinet the orientation of the dbx front and back are changed. Not sure what's going on here. Having tried rebuilding the drawer several times and I keep coming up with orientation correct in dbx editor but not in nesting.

I've attached pictures along with the dbx and cabinet file.
5-8 Aplply cookie sheet dbx.hsf
(264.02 KiB) Downloaded 81 times
Island- cookie sheet.hsf
(1.1 MiB) Downloaded 77 times
Nesting orientation problem.jpg
Incorrect orientation in nesting
Nesting orientation problem 1.jpg
Correct orientation in dbx editor

Don Thomson
Diamond Lake Custom Woodworks, LLC
Newport, WA

Scott Marshburn
Guru Member
Posts: 758
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Location: Jacksonville Nc

Re: Nesting orientation issue?

Postby Scott Marshburn » Sun, Dec 11 2016, 12:55PM

Hi Donald, I changed the grain direction from 90 to 0 and it nested fine
Yes! Oh Yes! I Think We Are Going to make It!

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 19 guests