Multiple part editor cuts

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Stuart Douglas
Junior Member
Posts: 72
Joined: Fri, Apr 10 2015, 7:57AM
Company Name: Bergman Custom Casework LLC
Country: UNITED STATES

Multiple part editor cuts

Postby Stuart Douglas » Wed, Aug 02 2017, 7:54AM

Is there a way to gang cut partitions? I'd like to cut all the partitions in a cabinet (84 of them!) using the part editor, WITHOUT taking each one into the part editor individually.

Clint Buechlein
Thermwood Team
Posts: 178
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Multiple part editor cuts

Postby Clint Buechlein » Thu, Aug 03 2017, 8:03AM

Stuart Douglas wrote:Is there a way to gang cut partitions? I'd like to cut all the partitions in a cabinet (84 of them!) using the part editor, WITHOUT taking each one into the part editor individually.


Unfortunately not an easy way to go about it. By chance are they all or mostly all the same part after the part editor cut is done? If so you can phantom part the extra ones, then just change your quantity when nesting.

-Clint-

Stuart Douglas
Junior Member
Posts: 72
Joined: Fri, Apr 10 2015, 7:57AM
Company Name: Bergman Custom Casework LLC
Country: UNITED STATES

Re: Multiple part editor cuts

Postby Stuart Douglas » Fri, Aug 04 2017, 5:59AM

Clint,

Thanks for the suggestion, that is an approach that would work in this case. So simple, I can't believe I didn't see that solution myself! :oops: That's why this forum is here. :beer:

I wonder if this is something the developers would find worthy of attention in their next release.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 7 guests