Changing dado depth on parts

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Changing dado depth on parts

Post by Donald Thomson »

Is there a way to set the depth of a dado on one end of, say a deck, different from the depth of the dado on the other end of the deck? For instance, let's say I would like a .375" dado on the right end, but a .5" dado on the left end.

I haven't seen anything anywhere for this but thought I'd ask, since there are so many hidden jems in this software.
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Scott Marshburn
Guru Member
Posts: 837
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: Changing dado depth on parts

Post by Scott Marshburn »

Hi,Donald.
This can be done by setting the dado depth for the deck to 1/2". Then setting the left or right inset for the deck to 1/8"
Post Reply