Adding a drawer issue ?

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Adding a drawer issue ?

Post by Donald Thomson »

I've got a little bit non standard cabinet I'm trying to add drawer boxes to. Cabinet is attached. The cabinet sides and back have a -3" top inset.

Basically after I add drawers - 7.75" lower drawer then an upper drawer to fit the remaining space - I go back to Main and the drawer boxes seem to be getting aligned with the top of the cabinet and not inside the faceframe where I added them.

In the previous version of eCabs, the dbx's were contrained within the faceframe. In the new version that doesn't seem to be happening. Is it something I'm doing wrong or is there something not working right in the software?

Thanks,

Don
Attachments
Don't think this is supposed to be the way it works?
Don't think this is supposed to be the way it works?
Sitting bench.jpg (9.61 KiB) Viewed 3255 times
Sitting bench.hsf
(2.13 MiB) Downloaded 311 times
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Adding a drawer issue ?

Post by Donald Thomson »

DISREGARD!!!

I think I found the problem.....
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Post Reply