I've got a little bit non standard cabinet I'm trying to add drawer boxes to. Cabinet is attached. The cabinet sides and back have a -3" top inset.
Basically after I add drawers - 7.75" lower drawer then an upper drawer to fit the remaining space - I go back to Main and the drawer boxes seem to be getting aligned with the top of the cabinet and not inside the faceframe where I added them.
In the previous version of eCabs, the dbx's were contrained within the faceframe. In the new version that doesn't seem to be happening. Is it something I'm doing wrong or is there something not working right in the software?
Thanks,
Don
Adding a drawer issue ?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 833
- Joined: Thu, May 14 2009, 11:41PM
- Company Name: Diamond Lake Custom Woodworks
- Location: Newport, WA
- Contact:
Adding a drawer issue ?
- Attachments
-
- Don't think this is supposed to be the way it works?
- Sitting bench.jpg (9.61 KiB) Viewed 3335 times
-
- Sitting bench.hsf
- (2.13 MiB) Downloaded 321 times
Sincerely,
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
-
- Guru Member
- Posts: 833
- Joined: Thu, May 14 2009, 11:41PM
- Company Name: Diamond Lake Custom Woodworks
- Location: Newport, WA
- Contact:
Re: Adding a drawer issue ?
DISREGARD!!!
I think I found the problem.....
I think I found the problem.....
Sincerely,
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com