Diagonal corner cabinet problems

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Stuart Douglas
Junior Member
Posts: 79
Joined: Fri, Apr 10 2015, 7:57AM
Company Name: Bergman Custom Casework LLC
Country: UNITED STATES

Diagonal corner cabinet problems

Postby Stuart Douglas » Tue, Apr 10 2018, 8:28AM

I have this cabinet that displays correctly, but does not nest or cut correctly. The top, deck, and fixed shelves are nested and defined to cut as pieces that are only a quarter of an inch wide, despite being correctly displayed in ECabS. Not sure how to remedy, or if I'll have to design this again from scratch in a different manner. Anyone run into this problem before?
Attachments
diag cab.zip
(167.64 KiB) Downloaded 28 times

Joe Soto
Guru Member
Posts: 333
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

Re: Diagonal corner cabinet problems

Postby Joe Soto » Tue, Apr 10 2018, 11:17AM

Not sure why but change if you change your blind dado placement from 2.19" to 2.25" it will fix your cabinet.

Stuart Douglas
Junior Member
Posts: 79
Joined: Fri, Apr 10 2015, 7:57AM
Company Name: Bergman Custom Casework LLC
Country: UNITED STATES

Re: Diagonal corner cabinet problems

Postby Stuart Douglas » Tue, Apr 10 2018, 11:33AM

Joe Soto wrote:Not sure why but change if you change your blind dado placement from 2.19" to 2.25" it will fix your cabinet.


That is a strange solution, but it works! I had set those blind dado insets to remove the tab created at the back of the shelf (and the top and deck, incidentally) and never looked at them again. Thanks for sleuthing that out. :beer:


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Exabot [Bot] and 14 guests