adj shelf height compartment not individually highlighting

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

TonyGiunta
Senior Member
Posts: 132
Joined: Tue, Jan 16 2007, 8:03PM
Company Name: ToSa Design
Country: UNITED STATES
Location: Sheffield, MA

adj shelf height compartment not individually highlighting

Postby TonyGiunta » Wed, Apr 25 2018, 9:54AM

Just upgraded to new build and have a cabinet with NO CUT adj shelves where I can't highlight individual sections to adjust shelf heights between adj shelves. Also each shelf not highlighting for individual shelf selection/deleting. Any input appreciated.
Attachments
PS_Cab_3.jpg
PS_Cab_3.jpg (12.13 KiB) Viewed 298 times
PS_Cab_3.hsf
(700.02 KiB) Downloaded 11 times

tim lucas
Guru Member
Posts: 300
Joined: Thu, Nov 29 2007, 5:18PM
Company Name: Tim Lucas Custom Woodworks LLC
Country: UNITED STATES
Location: bell, florida
Contact:

Re: adj shelf height compartment not individually highlighting

Postby tim lucas » Wed, Apr 25 2018, 4:25PM

If I zoom in tight on a shelf I can select it and delete it, I deleted all shelves and can add shelves but after adding a couple the problem comes back.

I tried with a standard frame-less cabinet and it works fine, not sure why your cabinet is corrupt?

Do you have more cabinets that act the same way or is it just this one?

Tim
Tim Lucas Custom Woodworks LLC
www.TLCW.us

TonyGiunta
Senior Member
Posts: 132
Joined: Tue, Jan 16 2007, 8:03PM
Company Name: ToSa Design
Country: UNITED STATES
Location: Sheffield, MA

Re: adj shelf height compartment not individually highlighting

Postby TonyGiunta » Wed, Apr 25 2018, 4:43PM

Hey Tim, yes I could delete a shelf if zoom in. I used a base cab I set up for a job a few months back. And now trying to convert into a tall pantry. Trying to avoid re -doing things... The NO CUT shelves have a shelf peg hole pattern for 1" stand off spacers for pullouts on Blum slides to clear hinges.
1st one at bottom has holes for spacer block then others above have multiple holes for pull out drawers to be adjustable.

But I need to place the shelves evenly to start so that pullouts are the same.

I guess I need to start from scratch with a standard cab... Just trying to save some time using my old cab with shelf peg spacing aligned with Blum hole spacing.'Thanks

tim lucas
Guru Member
Posts: 300
Joined: Thu, Nov 29 2007, 5:18PM
Company Name: Tim Lucas Custom Woodworks LLC
Country: UNITED STATES
Location: bell, florida
Contact:

Re: adj shelf height compartment not individually highlighting

Postby tim lucas » Thu, Apr 26 2018, 5:42AM

Instead of using your no cut wood, just use regular shelves then when you have them all set turn the shelves in phantom parts and they wont cut. you can change them back if you need to see them.
Tim Lucas Custom Woodworks LLC
www.TLCW.us

TonyGiunta
Senior Member
Posts: 132
Joined: Tue, Jan 16 2007, 8:03PM
Company Name: ToSa Design
Country: UNITED STATES
Location: Sheffield, MA

Re: adj shelf height compartment not individually highlighting

Postby TonyGiunta » Thu, Apr 26 2018, 6:00AM

Thanks Tim.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 10 guests