Changing grain direction
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 118
- Joined: Sun, Oct 19 2014, 8:33PM
- Company Name: Frank Raffaele and Sons Custom
- Country: UNITED STATES
Changing grain direction
Is it possible to change the direction of cabinet backs so if I have a cabinet that is 40" tall and 95" wide I can install the back accordingly so as not to have a seam. I see that I can manipulate the grain direction but doesn't change the width and length specs.
-
- Guru Member
- Posts: 833
- Joined: Thu, May 14 2009, 11:41PM
- Company Name: Diamond Lake Custom Woodworks
- Location: Newport, WA
- Contact:
Re: Changing grain direction
I think you could create a new sheet good that is the size you are looking for. So instead of the length being 96, make it 40. And make the width 95 instead of 48.
Sincerely,
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Changing grain direction
Yes you can change the grain. Take the cabinet to the editor click on the back and enter the angle you need. You can change any sheet good the same way - sides , deck top ...
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us