Inset 6 cannot be to the left of parent part...Really

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Carmen Addamo
Senior Member
Posts: 110
Joined: Sun, Oct 19 2014, 8:33PM
Company Name: Frank Raffaele and Sons Custom
Country: UNITED STATES

Inset 6 cannot be to the left of parent part...Really

Postby Carmen Addamo » Wed, Oct 17 2018, 6:31PM

I assume this was done on purpose in the new build. Why was this changed. That was a big advantage to set stretcher insets to zero. Now you have to give a stretcher a negative value and when you chage material thickness all those insets have to be reset. What about the weeks and months that went into building a library with all those insets set to zero. What happens to all those cabinets

Clint Buechlein
Thermwood Team
Posts: 394
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Inset 6 cannot be to the left of parent part...Really

Postby Clint Buechlein » Thu, Oct 18 2018, 7:33AM

Carmen,

Can you post one of the cabinets and a full description of what you are changing? There's always a possibility a bug was introduced inadvertently and we need a repeatable scenario to work with.

-Clint-

Carmen Addamo
Senior Member
Posts: 110
Joined: Sun, Oct 19 2014, 8:33PM
Company Name: Frank Raffaele and Sons Custom
Country: UNITED STATES

Re: Inset 6 cannot be to the left of parent part...Really

Postby Carmen Addamo » Thu, Oct 18 2018, 9:59AM

Clint here is a library cabinet where the #5 and #6 insets for the end panel spacers were set to zero. I would use this same practice for a left side wall filler on a euro box. The #6 inset would be associated to the left end/left and set to zero so no matter the width of the filler it would always be in the proper position. If I try to highlight the spacer now and associate again I will get the promt mentioned.

Base Cabinet w EP and Adj Shelf.hsf
(2.32 MiB) Downloaded 102 times

Carmen Addamo
Senior Member
Posts: 110
Joined: Sun, Oct 19 2014, 8:33PM
Company Name: Frank Raffaele and Sons Custom
Country: UNITED STATES

Re: Inset 6 cannot be to the left of parent part...Really

Postby Carmen Addamo » Fri, Nov 30 2018, 5:20AM

Seems like this issue was never addressed in the recent build.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 8 guests