corner cabinet toe kick

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Joe Soto
Guru Member
Posts: 345
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

corner cabinet toe kick

Postby Joe Soto » Wed, Feb 06 2019, 5:23PM

toe kick .jpg

I can not figure out why the toe kick notch is 1/4" shorter on this side. I've used this same cabinet for several years without a problem.
I cut this cabinet today and both ends cut like this but Ecabs only shows it on the left. The only recent changes were I added some screw holes to the dados and changed the material of the top and toe kick. The only setting I can change to correct it is the negative inset into the face frame but it seems to be working in reverse. Change the left side to 0" and the right side notch gets smaller.
Attachments
36 pie cutCorner Framed fixed.hsf
(1.28 MiB) Downloaded 48 times

User avatar
Kerry Fullington
Wizard Member
Posts: 4595
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: corner cabinet toe kick

Postby Kerry Fullington » Thu, Feb 07 2019, 12:46PM

Joe,
I opened your cabinet in the cab editor and then went to Construction Settings/Toe Kick tab and exited without changing anything and this is what I got.

Clipboard01.jpg

Joe Soto
Guru Member
Posts: 345
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

Re: corner cabinet toe kick

Postby Joe Soto » Thu, Feb 07 2019, 1:38PM

That's the way it came off the router too but I need the toe to be flush with the notch.

Rick Deskins
Thermwood Team
Posts: 854
Joined: Tue, May 17 2005, 12:47PM
Company Name: Thermwood
Country: UNITED STATES
Location: Thermwood

Re: corner cabinet toe kick

Postby Rick Deskins » Thu, Feb 07 2019, 1:50PM

For some reason, the part editor is holding on to this added material. I would take each part into the PE editor, go to contour mode, create edges, and save off the geometry. Then exit PE editor, remove PE cuts from the Left and Right End. Then reapply the PE cuts to those parts.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900

Joe Soto
Guru Member
Posts: 345
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

Re: corner cabinet toe kick

Postby Joe Soto » Thu, Feb 07 2019, 2:11PM

Got it, removed left end part editor cuts and reapplied them. All is well. Thanks


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 10 guests