User Defined Operations

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Kerry Fullington
Wizard Member
Posts: 4604
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

User Defined Operations

Postby Kerry Fullington » Thu, Feb 14 2019, 1:53PM

Where can I learn about User Defined Operations.

Scott Marshburn
Guru Member
Posts: 773
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: User Defined Operations

Postby Scott Marshburn » Thu, Feb 14 2019, 4:24PM

Hi Kerry, During the beta test they posted a couple of links to videos from their training videos on how to use this feature. However, it seems that the links have been removed from the beta testing forum.

User avatar
Kerry Fullington
Wizard Member
Posts: 4604
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: User Defined Operations

Postby Kerry Fullington » Thu, Feb 14 2019, 8:00PM

Hey Scott,

Good to hear from you.

I remember those links but couldn't find them again. I browsed through the videos on the training site but didn't see anything there either.
I have looked at the help links in the software but they just confuse me.

Clint Buechlein
Thermwood Team
Posts: 420
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: User Defined Operations

Postby Clint Buechlein » Fri, Feb 15 2019, 8:35AM

Kerry,

If you have access to the training videos, you can find the same videos that were in the beta forum under the What's New section for version 6.2.2.

-Clint-

User avatar
Kerry Fullington
Wizard Member
Posts: 4604
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: User Defined Operations

Postby Kerry Fullington » Fri, Feb 15 2019, 10:14AM

Thanks Clint,

I found them earlier this morning.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 15 guests