User Defined Operations

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

User Defined Operations

Post by Kerry Fullington »

Where can I learn about User Defined Operations.
Scott Marshburn
Guru Member
Posts: 837
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: User Defined Operations

Post by Scott Marshburn »

Hi Kerry, During the beta test they posted a couple of links to videos from their training videos on how to use this feature. However, it seems that the links have been removed from the beta testing forum.
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: User Defined Operations

Post by Kerry Fullington »

Hey Scott,

Good to hear from you.

I remember those links but couldn't find them again. I browsed through the videos on the training site but didn't see anything there either.
I have looked at the help links in the software but they just confuse me.
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: User Defined Operations

Post by Clint Buechlein »

Kerry,

If you have access to the training videos, you can find the same videos that were in the beta forum under the What's New section for version 6.2.2.

-Clint-
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: User Defined Operations

Post by Kerry Fullington »

Thanks Clint,

I found them earlier this morning.
Post Reply